22
CONFIGURATION MENU
Accessing Configuration Menu
Configuration is accessed from
CONFIGURE
menu selection on main menu.
1. From target torque or angle screen, press and hold
ENTER
button
for 3 seconds.
2. Highlight
CONFIGURE
menu selection using
UP
/DOWN
buttons.
3. Press
ENTER
button
to display Configure menu.
Menu Selections:
•
EXIT - Exits Configure menu and returns to target torque or angle screen.
•
MODE SETUP - Displays wrench mode setup menu.
•
DELETE PRE-SETS - Displays delete all pre-sets menu.
•
CALIBRATION - Displays wrench calibration menu (password protected
– default factory setting
91748).
•
SET DATE/TIME - Displays clock date and time entry screens.
•
SET CAL INTRVAL - Displays calibration interval setup screen (requires clock date and time setup).
4. To exit Configure menu and return to target torque or angle screen, press
ENTER
button while
EXIT
menu selection is highlighted.
NOTE:
All user configurable settings are stored in non-volatile memory and are retained while
power is off.
Mode Setup
Mode setup menu allows user to enable/disable Torque THEN angle mode.
1. From Configure menu, press
ENTER
button while
MODE SETUP
selection is highlighted.
2. Mode Setup menu is displayed.
Menu Selections:
•
EXIT - Exits Mode setup menu and returns to Configure menu screen.
•
THEN DISABLED - Displays THEN Mode enable/disable screen.
3. Use
UP
/DOWN
buttons to highlight menu selections.
4. Press
ENTER
button while
EXIT
menu selection is highlighted to return to Configure menu.
