NorAM 65ET T4 FINAL, Operator'S Manual

Page: 111 / 194

NORAM 65ET GRADER
4-33
Lubrication and Maintena
nce - Grader Compon
ents
4
Every 1000 Hours or 6 Months
E
VERY
1000 H
OURS OR
6 M
ONTHS
Transmission Oil and Filter - Change
Change transmission oil and filter at the same time.
1. Support bottom transmission cover and remove bolts
securing rear of cover and lower rear of cover to the
ground.
2. Remove plug and drain transmission oil.
3. Clean filter area before removing filter
(1)
. Discard
filter.
4. Apply thin film of new, clean oil to sealing ring on the
new filter and install.
The mounting of the filter must be carried out as follows:
• Cover the gasket with a small amount of oil.
• Screw the filter in until contact with the sealing surface is obtained and tighten it now by hand
about 1/3 to 1/2 turn.
5. Install drain plug and refill transmission to correct level on dipstick. Start engine and do final
check with oil temperature above 80–90° C (176–194° F).
NOTE:
At every oil change, the ZF-Fine filter must be replaced. In addition, ZF recommends to
start the autonomous calibration of the shifting elements (AEB).
1