NorAM 65ET T4 FINAL, Operator'S Manual

Page: 124 / 194

NORAM 65ET GRADER
4-46
When Required
1
4
Lubrication and Maintenance - Grader Components
Battery - Charge
Never make or break any of the charging circuit connections, including the connection at the
batteries, when the engine is running. Never short any of the charging components to the ground.
DO NOT use a booster battery or charger of more than 12 volts.
Always observe correct polarity when installing batteries or using a booster battery to jump start the
engine. Connect positive to positive and negative to negative.
Always turn the master switch OFF when charging the battery in the motor grader with a battery
charger.
Inside the right side access panel is a Master Switch for the electrical system. Before charging the
battery, turn the master switch OFF and remove key to prevent others from activating any electrical
circuits.
1. Remove top panel.
2. Attach charging device (booster battery or battery
charger) to terminals of the battery. Observe polarity,
connecting positive to positive before connecting negative
to negative.
3. Allow battery time to charge. Longer charges at lower
current are recommended.
4. Disconnect charging device, negative terminal before
positive terminal.
5. Turn master switch ON.
6. Start engine using normal starting procedures.
Batteries contain sulfuric acid. in case of contact with skin, flush affected area
with water for five minutes. Seek medical attention immediately. Avoid contact
with the skin, eyes or clothing. wear eye protection when working near batteries.
Battery posts, terminals and related accessories contain lead compounds,
chemicals known to the state of California to cause cancer and reproductive
harm. Wash hands after handling.