NorAM 65ET T4 FINAL, Operator'S Manual

Page: 146 / 194

NORAM 65ET GRADER
6-4
Every 10 Hours or Daily
1
6
Lubrication and Maintena
nce - CAT Tier 4 Final
E
VERY
10 H
OURS OR
D
AILY
Refer to the Engine Operation and Maintenance Manual supplied with the machine for engine
maintenance information.
Engine Coolant Level - Check
Fill to within 1/2” (13mm) of bottom of fill pipe with a low-silicate (ethylene glycol) antifreeze and
clean water mixture.
NOTE:
Never add pure antifreeze to a cooling system. We recommend using a 50/50 mixture.
Never use high-silicate antifreeze that is higher than a 60/40 mixture.
1. Remove the cooling system fill cap
(1)
slowly in order
to relieve pressure.
2. Maintain the coolant level within 1/2” (13 mm) of the
bottom of the fill pipe.
3. Clean the cooling system fill cap and check the
condition of the fill cap gaskets. Replace the cooling
system fill cap if the fill cap gaskets are damaged.
Reinstall the cooling system fill cap.
4. Inspect the cooling system for leaks.
Engine Air Cleaner Service Indicator - Check
When red indicator reaches the window on indicator
(1)
replace air filter element. Push button
(2)
to reset
indicator.
DO NOT remove element until the indicator show it
needs to be replaced.
NOTICE:
The air restriction indicator will not function
properly if:
• Element is damaged or not seated properly in
housing.
• Air cleaner element body is damaged. If so, unfiltered air may enter engine.
• Air transfer duct between air cleaner and engine is damaged or the clamps are loose.
• Air duct between air cleaner and restriction indicator is damaged or pinched.
Hot fluid under pressure can scald. Allow engine to cool before opening radiator
cap. Check the coolant level when the engine is stopped and cool.
1
1
2