39
Figure 40: Tilt Valve Calibration Screens
9.
Select the Enter button (A) to begin calibration.
10.
Follow the instructions on screens 1 – 3 then press the Enter button (B).
11.
Follow instructions on screen 4 then press the Cal icon (C).
12.
When the calibration is complete, press the Enter button (D) to exit calibration.
13.
Table 2 shows examples of “before” and “after” calibration values. The new values should
be slightly higher to account for the additional UC5 wiring on the John Deere valve.
Table 2: Calibration Value Examples
Function Calibration
before
UC5
Installed
Calibration after UC5
Installed
Left Up
550
860
Left Down
600
910
Right Up
620
860
Right Down
620
900
14.
Test Autofold and confirm that it is functioning properly. If it is not, repeat the calibration
procedure.
B
D
C
Summary of Contents for UC5 Topcon X30
