Norac UC5 Topcon X30, Installation Manual, Page: 37 / 50

34
e) Using the sprayer’s controls raise the boom center to the maximum height and level the wings.
f) Follow the symbols below to navigate to the manual valve drive screen.
g) Use the roll arrows to roll the boom over as far as possible in each direction a few times,
allowing the air to escape. *Don’t adjust the wings individually, only use the roll arrows.
h) Stop with the wings at approximately the same height.
i) Ensure that each roll button allows for the boom to rotate in both directions. If the boom
doesn’t roll in one direction, roll it the opposite way and adjust the wings to their level position.
3. Run a complete automatic install.
11.1.2 Using an AgLeader Proprietary Display
This section is only for AgLeader displays with the UC5
TM
on the proprietary display. If the UC5 is
operating on the VT within the AgLeader screen, follow the procedure in Section 11.1.1.
4. Remove the air from the tilt cylinders, using the sprayer’s joystick controls.
a) Move the left tilt cylinder full stroke three times.
b) Move the right tilt cylinder full stroke three times.
5. Remove air from the roll channel using the AgLeader display:
a) Start an Automatic Install (
Figure 34
and Figure 35).
b) Select the appropriate sprayer make and model on the screen.
c) Read the disclaimer menus and move through the screens.
d) At the screen reading “level the boom at 35in”, press the picture of a house.
e) Using the sprayer’s controls raise the boom center to max height and level the wings.
f) Navigate to the roll gain screen (
Figure 34
and Figure 36).
g) Press the manual gain test a few times for each direction to allowing the air to escape. Don’t
adjust the wings individually; only use the roll gain tests.
h) Stop with the wings at approximately the same height.
i) Ensure that each roll button allows for the boom to rotate in both directions. If the boom
doesn’t roll in one direction, roll it the opposite way and adjust the wings to their level position.