14
6.4
Wing Sensor Installation
1.
The sensor bracket should be oriented forward (ahead of the boom).
2.
Typically the best mounting location for the wing sensor brackets will be near the end of
the boom tips, approximately two feet (60cm) from the end.
3.
Depending on the boom design, some breakaway sections will lift upwards as they break
back. If the sensor is mounted to this portion of the boom, the system will force the boom
downwards towards the ground as the boom folds backwards.
4.
Use M07, M08 and M09 in place of the supplied hardware to mount the brackets.
5.
Mount the NORAC UC5 ultrasonic sensor into the sensor bracket and run the sensor
cable either through hole in the back or through the side cut-out and behind the bracket.
Ensure the cable is clear of moving parts and will not be damaged during folding.
Figure 8: Bracket Mounting Example
Figure 9: Wing Sensor Bracket Mounting
If the Severe Terrain option is being installed, refer to Appendix A: Optional Severe Terrain
Sensor Mounting for instuctions on mounting the inner sensor brackets.
Front
Summary of Contents for UC5 Topcon X30
