23
9
Connecting the Sensors to the CANbus
1.
Fasten the 8-way coupler to the boom with cable ties. The recommended mounting
location is shown in
Figure 12
.
2.
Route cable C03 from the input module to the 8-way coupler (E11).
3.
Connect the position sensor (E06) to the 8-way coupler using cable C02 and a 2-way
coupler (E12). Cable C02 and item E12 may not be needed if the 8-way coupler is mounted
close enough to the position sensor.
4.
Connect the wing roll cylinder (H20) to the 8-way coupler.
5.
Connect the main lift sensor to the 8-way coupler using cable C02 and a 2-way coupler
(E12).
6.
Connect two cables (C05) to the 8-way coupler and route along the booms to the wing
sensors. Follow existing cables and hoses to be sure the cable will not be pinched or
stretched.
7.
At the sensor brackets, attach a 2-way coupler with terminator (E20) to the sprayer boom.
Plug the sensor and the CANbus cable into the 2-way coupler.
8.
Insert the 6 pin plugs (P03) into the remaining receptacles of the 8-way coupler.
Ensure that all unused connectors are plugged with the plugs provided.
Summary of Contents for UC5 Topcon X30
