25
3.
Using the supplied 1 inch bolt and two spacers, install the damper end (one port) of the
linear roll cylinder onto the top mounting bracket. There must be a spacer on each side of
the spherical bearing. The damper should be mounted on the back side of the mount
(between the mount and boom).
Figure 24: Linear Roll Cylinder Top Mount (Top View)
4.
Using the other 1 inch bolt and spacers, attach the cylinder end of the linear roll cylinder to
the bottom mount. Be careful not to move the shaft of the cylinder because doing so will
push oil out and suck air in.
5.
Tighten both the top and bottom linear roll cylinder mounting bolts to 500 ft-lbs.
Figure 25: Bottom Linear Roll Cylinder Mount
Spring Washer
Spacers
Spring Washer
Spacers
