26
4.8 C
OMPLETING THE
I
NSTALLATION
1.
Start up your sprayer and test the
sprayer’s functionality. The NORAC
Control Panel does not need to be
powered up for the original switches to
function. Unfold the booms and
raise/lower each boom and main section.
Confirm that the cabling and hoses
are agreeable to the entire range of
motion.
2.
If any functions do not work, review the
hydraulic and electrical portions of this
manual to check for proper installation.
If you still have trouble, contact
NORAC for assistance.
3.
Turn on the power for the UC4+ Control
Panel using the switch on the side of its
chassis.
4.
Repeat the Boom Speed Test as
described in Section
4.2
Boom Speed
Test
with the NORAC UC4+ System
installed. Record the results for
comparison in
Table 6
.
5.
The procedure for the installation of the
UC4+ Spray Height Control system is
now complete. Begin the AUTOMATIC
SYSTEM
SETUP
procedure
as
described in the
UC4+ Spray Height
Control Operator’s Manual
(
M01
).
Summary of Contents for UC4 Plus Rogator 1286C
