17
4.5.1 Boom Roll Sensor Mounting
The boom roll sensor (
E04
) must be
mounted to the rotating part of the boom.
Follow these guidelines and refer to
Figure 16
to mount the sensor.
a)
Make sure you are using the roll
sensor that does NOT have a
temperature probe (only one cable)
(
E04
).
b)
The boom roll sensor must be
mounted to the rotating part of the
boom suspension.
c)
Use cable-ties to secure the bracket
to a square edge feature (square
tube).
d)
Ensure the AMP (circular) connector
exits towards the Right Hand Wing
(when looking from the rear of the
sprayer).
e)
Securely cable-tie the connector to
the frame.
4.5.2 Chassis Roll Sensor Mounting
The chassis roll sensor must be mounted
to a non-rotating part of the boom. To
mount the chassis roll sensor, follow the
following guidelines and refer to
Figure
16
.
a)
Make sure you are mounting the roll
sensor that does have a temperature
probe (2 cables) (
E03
).
b)
Mount the chassis roll sensor (
E03
)
to a non-rotating part of the boom.
c)
Cable-tie the bracket to a square
edge feature (square tube).
d)
The
AMP
(circular)
connector
MUST
exit towards the Right Hand
Wing (when looking from the rear).
e)
Securely cable-tie the connector to
the frame.
Figure 16 – Boom and Chassis Roll Sensors Correctly Mounted
E04
E03
Summary of Contents for UC4 Plus Rogator 1286C
