24
Figure 25 – Cable Configurations: C11, C12 and C03
10.
Route
C11
to the rear of the sprayer, in
the vicinity of the valve block.
11.
Connect the Interface cable (
C12
) to the
mating connector on
C11
(
Figure 25
).
12.
Route the free end of
C12
to the Rogator
valve block.
13.
Tee the Deutsch connectors into the
connectors on the sprayer solenoids. To
tee in, unplug the existing connector
from the solenoid and insert the NORAC
plug. Connect the Rogator plug that was
disconnected, to the receptacle end of
the tee on the NORAC cable. The
cables to be teed in are shown in Table
7.
One of the tees marked “MAIN
UP” will not be used.
Table 7 - Rogator and NORAC Valve
Labels
Rogator Label
NORAC Label
LH FOLD UP
LEFT UP
LH FOLD DN
LEFT DN
RH FOLD UP
RIGHT UP
RH FOLD DN
RIGHT DN
HOIST UP
MAIN UP
HOIST DN
MAIN DN
14.
Connect the 6-pin Tower on the valve
cable (
C03
) to the mating connector on
C10
(
Figure 25
).
Summary of Contents for UC4 Plus Rogator 1286C
