23
2.
Connect the UC4+ power cable (
C10
) to
the UC4+ Control Panel in the sprayer
cab. Ensure that both plugs are
connected to the receptacles of the panel
(
Figure 23
).
Ensure the UC4+ control panel’s
power is OFF for the remaining
installation (Bottom of switch
pressed IN). Use caution when
handling the 12 V power line of
the Rogator wiring.
3.
Connect the power pigtail interface cable
the mating connector on
C10
.
4.
There is an access hole to the sprayer
electrical panel on the rear right corner
of the cab. Route the free end of
C14
to
the electrical panel through this hole.
5.
In the electrical panel wire the white
wire on
C14
to +12V and the black wire
to Ground. Each polarity is labeled on
the wire. Refer to for
Figure 24
recommended
+12V
and
Ground
connections inside of the electrical
panel.
6.
Install the provided 15A automotive fuse
into the slot beside the +12V power
connection.
Figure 24 – Power and Ground Connections
8.
Route
C10
to the exterior of the cab.
There is an access panel located on the
rear right corner of the cab floor. Use
this panel to route
C10
through.
9.
Connect the 16-pin AMP plug of the
valve extension cable (
C11
) to the free
end of
C10
on the outside of the cab
(
Figure 23
).
Connect
GROUND
wire here
C12V wire
(spade terminal) here
and install 15A fuse
Summary of Contents for UC4 Plus Rogator 1286C
