The control board has several micro-switches to activate a lot of functions in order to fi nd suitable solutions for the user and to make the
installation more safety.
3
Operating and regulation modes
3.1 Logic Function
1 2 3 4 5 6 7 8 9 10
DIP
1-OFF 2-OFF
AUTOMATIC 1
By each control it reverse. It recluse automatically at the end of the
pause time.
1-ON 2-OFF
COLLECTIVE USE
When opening and in pause time it doesn’t accept any control, it
reclose automatically at the end of the pause time.
1-OFF 2-ON
PARTIALLY
AUTOMATIC
Each control the sequenze is
OPEN-STOP-CLOSE-STOP
etc. It
doesn’t reclose automatically.
1-ON 2-ON
AUTOMATIC 2
By each control the sequence is
OPEN-STOP-CLOSE-STOP
etc.
It reclose automatically at the end of the pause time
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3
4 5 6
8 9 10
1 2
7
3-ON
Dead Man
Function
It activate the Dead Man function Par. 3.2
4-OFF
signal light
Connect a signal light in the terminals 15-16
4-ON
automatic brake
in case an automatic brake is connected in the terminal 15-16
6 se DIP 4 OFF
Pre-lighting
It activate the pre-lighting before each cycle
6 se DIP 4 ON
exterior
brake
OFF: if the brake is activated when it is not powered
ON: if the brake is activated when the brake is activated
7-ON
Internal
Brake
IT activate the integrated brake and it works when the gate stops,
after that the brake will be released and the motor can work properly
9-ON 10-ON
Radio partial
opening
It activate the partial opening throught the radio receiver . if you use
this set up the terminals OUT 2 must be free
3
4 5 6
8 9 10
1 2
7
3
4
5 6
8 9 10
1 2
7
4 5
8 9 10
1 2
7
4 5
8 9 10
1 2
7
4 5 6
8 9 10
1 2
4 5 6
8
1 2
7
6
3
6
3
3
3
7
9
9
3
4
5 6
8 9 10
1 2
7
10
3.2
DEAD MAN FUNCTION
If you put the DIP3 the OPEN and CLOSE function changes and also the input for photo-beams
Setting the DIP3 it changes the function of the OPEN/CLOSE and the input of the PHOTOCELL
The command OPEN and CLOSE become PARTIAL OPENING. This mean that when the command is
released , the motor stops immediatelly. The command START /PARTIAL OPENING work automatically
but in case the command OPEN/CLOSE is activated the control panel doesn’t accept any command
START/PARTIAL OPENING until the gate is closed. During the Deadman function the control panel check
all securities excepted the obstacle detection. The input PHOTOCELL is checked even when the gate is
opening. The gate stops until the normal condition of that input ( closed contat)
3
7 2
4
