nologo START-S7LT, Manual And Operating Manual For The Installer

Page: 41 / 120

START-S7lT
operating guide
-17-
The control unit dispose of a BUTTON P1 to programm the time and the memorization of the remote controls.
If you memorize a SMIle-C, make sure that all buttons have a code otherwise you need to generate a
new code. If you need to memorize a rolling code SMIle-H you don’t need to self-generate a code.
The ouputs need to be dactivated, so no contacts available and lights should be turned off.
This procedure is possible only when the gate is closed. LED L1 has to flash regularly see
“Activation of codes” in the previous paragraph.
CONNECT THE ANTENNA ONLy AFTER LEARNING OF REMOTE CONTROL CODES!
1
Press and release button P1 in the control board, led l1 will lit on for 6 seconds. Then...
2
In 6 seconds press the button of the remote controls which OPENS (START) we suggest the first
channel. LED L1 will flash 5 times to confirm the operation and it will flash regularly. Code OPENS
memorized.
If LED L1 will flash regularly without flashing 5 times, it means that the memory
code is full and it doesn’t accept any remote controls.
For 20 bits the capacity of the code is 22 codes,
If you need to memorize more codes you need to install a supplementary receiver RX2 or RX4
with a capacity of 3000 codes.
If you are not sure that this procedure is correct start from point no.1 again but cancel the memory before.
It is important to start from the previous chapter (Cancellation of the memory)
This function works in the DIPA 1 and 2 see “Logic of function”:
1
Press and release button P1 in the control board, led l1 will lit on for 6 seconds. Then...
2
In this time
press and release button P1
in the control board,
LED L1
will lit on for 6 seconds and then..
3
Press and release the button of the remote control which CLOSE we suggest the 2nd channel.
This function has the following logic:
CLOSE-STOP-CLOSE
it cannot be changed.
Led L1 will flash for 5 times and it will flash as in the beignning. The code has benen memorized
This function has the following logic: CLOSE-STOP-CLOSE and it cannot be changed:
Memorize the first channel of the remote OPEN (START)
Memorize the second channel of the remote CloSe
6.3
Memorization of the codes