START-S5PV
Technical manual
-13-
To manage the remote controls, the control unit should have a receiver. The control unit can manage different type of codes,
the fi rst memorized code will determine the type of code, consequently it cannot be memorized different codes from the fi rst.
The receiver will accept 12 to 64 bit codes.
4
Installation of the plug-in receiver and managing of the REMOTE CONTROL
4.1 Installation of the hybride
WARNING! The installation of the receiver should be done when
the control unit is not powered.
WARNING! The hybride should be plug-in in the correct side:
components at the exterior side of the control unit
WARNING! If the hybride will take away and the codes are already
memorized, you have to cancel the memory
(see next chapter CODICI; CANCELLATION OF THE MEMORY)
4.2 Cancellation of the MEMORY CODE
This operation cancel all previous memorized codes. It is not prevue the cancellation of a single code.
It is necessary to reset the memory before learning the fi rst remote control.
The cancellation of the memory is possible only when the gate is in closed POSITION.
ON
CTS
2
1
4
3
6
5
8
7
10
9
1
Make sure that the micro-switch no.5 of DIPA is in OFF position.
The automation is closed.
2
Keep pressed the button P until the led TEST start fl ashing
3
Wait until the led TEST starts fl ashing
15 seconds
4.3 MEMORIZATION of a single remote control
The memorization of a code is possible when the gate is CLOSED:
ON
CTS
2
1
4
3
6
5
8
7
10
9
1
Make sure that the micro-switch no.5 of DIAP are in OFF position.
The automation is closed.
2
Make sure that the micro-switch no.5 of DIP A are in OFF position.
The automation is closed.
3
Press and release slowly the button of the remote control which should be asso-
ciated to the control START. The led TEST fl ashes 6 times and 1 time slowly and
then it is lit on for 10 seconds (START code memorized)
4
You have 10 seconds time to press and release slowly the button of the remote
control which should be associated to the PARTIAL OPENING control ( second
button of the remote control). The led TEST fl ashes fastly for 6 times and then
normally.
- If you need to memorize another remote control repeat the passage no.1
- If you don’t need to associate any control to PARTIAL OPENING, don’t do the passage no.4 wait for 8 seconds and 1 fl ashing for the l.e.d. TEST and
then the lamp fl ashes normally.
- If you press the remote control and the l.e.d. TEST is lit on, it means that the remote control is not COMPATIBLE
- If you press the remote control and the l.e.d. TEST fl ashes slowly it means that the memory is full.
- This control unit cannot cancel one single code
Component
side at the
exterior
side of the
control unit
START
PARTIAL
OPENING
