INSTRUCTIONS FOR USE
•
VISOR MECHANISM SYSTEM
1 DISASSEMBLY
1.1 Open the visor completely.
1.2 By pressing the visor release button (A), slide the visor forwards until you hear a click (Fig. 1).
1.3 Release the visor fastenings (B1 and B2) from their seat (Fig. 2).
1.4 Repeat the same steps on the other side of the helmet.
2 ASSEMBLY
2.1 Set the visor in open position by placing the visor fastenings (B1 and B2) into their seats in
the visor mechanism (Fig. 2).
2.2 Insert fastening B1 in the housing provided and press the visor against the shell in line with
fastening B2.
2.3 Slide the visor backwards until the visor locks into place.
2.4 Repeat the same steps on the other side of the helmet.
WARNING!
-
After each assembly or disassembly procedure of the different parts, check that the visor
mechanism works properly by pulling the visor up and down; if necessary, repeat the steps
described above.
-
Do not remove the visor pulling up/down mechanisms from the shell.
-
If the visor opening/closing mechanisms are not working properly or if such mechanisms get
damaged, please contact a Nolan authorized dealer.
•
(Available as standard or optional accessory)
1
PINLOCK
®
INNER VISOR ASSEMBLY
1.1 Remove the visor.
1.2 Make sure that the inner surface of the visor is clean and check that the pin adjustment exter-
nal levers are turned inwards.
1.3 Place the Pinlock
®
inner visor on the visor. WARNING: The silicone-sealed profile of the
Pinlock
®
inner visor should be in contact with the inner surface of the visor.
1.4 Insert one side of the Pinlock
®
inner visor on one of the visor pins and hold it in position
(Fig. 3).
1.5 Widen the visor and fasten the other side of the Pinlock
®
inner visor to the second pin (Fig. 4).
1.6 Release the visor.
1.7 Remove the protective film from the Pinlock
®
inner visor and check that the entire silicone-
sealed profile of the inner visor adheres to the visor.
1.8 Fit the visor in the helmet.
CHECKING AND ADJUSTING THE INNER VISOR STRETCHING
Check the correct system assembly by opening and closing the visor. Check that both visors are
correctly fastened and do not move.
If the inner visor is not tightly fixed to the visor, move the external adjustment levers simultane-
ously upwards to increase the stretch (Fig. 5). This operation must be carried out gradually. The
maximum stretch is achieved when the pin adjustment external levers are turned outwards.
12
Summary of Contents for N86
