1.4 Turn the latch 90° towards the rear part of the helmet (see Fig. 15). Carry out this
operation by pushing the latch towards the inside of the helmet. Fix the latch by
positioning the safety cover (see Fig. 1 A). Make sure the cover is firmly attached
to the latch.
1.5 Follow the same steps on the right side of the helmet.
WARNING!!!
-
Do not use the helmet if the peak has not been assembled properly.
-
If the visor opening/closing mechanisms are not working properly or if such mech-
anisms get damaged, please contact a Nolan authorized dealer.
2
PEAK DISASSEMBLY
2.1 Lift the safety cover from the latch as shown in Fig. 1 A, rotate the latch 90° towards
the front part of the helmet (see Fig. 1B).
2.2 Remove the latch from the helmet by pulling it outwards so that the latch inner bay-
onet “A” comes out of its housing in the visor mechanism (see Fig. 14).
2.3 Follow the same steps on the right side of the helmet.
2.4 Remove the peak by holding its side end and bending it outwards so that the hole
“B” of the peak comes unhooked from the visor mechanism and the inner pawl “C”
inside the peak comes out of its housing in the visor mechanism (see Fig. 13).
2.5 Repeat the steps 1, 2, 3 and 4 of the visor assembly section.
17
Summary of Contents for N43E
