Nolan N43E, Safety And Instructions For Use

Page: 14 / 76

- The VPS antifog/antiscratch treatment remarkably reduces fogging. Protracted
periods of adverse weather and/or environmental conditions might cause fogging
and/or formation of condensation on the VPS, which entails a reduction of visibility
and/or sharpness of vision: In this case, deactivate the VPS.
- In case of rain, the direct contact of raindrops with the antifog/antiscratch-treated
VPS quickly reduces sharpness of vision, thus causing scarce visibility: In this case,
deactivate the VPS.
- The special VPS antifog treatment is usually sensitive to high temperatures or heat
sources. In this case, contaminations caused by contact with other materials might
occur. These contaminations will cause marks and stains to develop. In these cases
(e.g. when the helmet is kept in the top case), it is recommended to make sure the
visor is not touching other materials.
VPS DISASSEMBLY INSTRUCTIONS
To remove the VPS system from the helmet, open or disassemble the visor of the hel-
met and lower the VPS by pushing the slider upwards (Fig. 4B).
Hold the central part of the VPS, press it slightly towards the inner part of the helmet
and simultaneously pull the VPS downwards until its upper grip pawl has been removed
from the shell (Fig. 5).
Hold the VPS right side and pull the VPS towards the outside of the helmet by press-
ing the grip pawl in the shell housing (Fig. 6).
Repeat the same operation on the left side of the helmet.
VPS ASSEMBLY INSTRUCTIONS
To assemble the VPS, open or disassemble the helmet visor and make sure the side
slider is in upward position (Fig. 4B).
Insert the VPS left end into the left side guide until the grip pawl is hooked in shell housing.
Repeat the same steps on the right side (Fig. 6).
Press the VPS slightly inwards near its upper grip pawl. At the same time press the
VPS in the seat obtained between the outer and inner shells (Fig. 5).
Push the VPS upwards, making sure that the side slider is moving upwards (Fig. 4B).
Check the correct VPS operation by moving the left side slider downwards (Fig. 4A) and
upwards (Fig. 4B) until you hear the clicks meaning that it is in the relevant positions.
If necessary, repeat the above-mentioned steps.
-
If the visor and/or VPS opening/closing mechanisms are damaged or malfunction-
ing, please contact a Nolan authorised dealer.
- Do not use the helmet if the VPS has not been assembled properly.
WARNING
- The VPS doesnʼt replace the protection guaranteed by the visor.
14