Nokia IP390 - Security Appliance, Installation Manual

Page: 37 / 97

IP390 Security Platform Installation Guide 37
4
About IP390 Appliance Network
Interface Cards
This chapter describes the PMC network interface cards (NICs) available for the IP390
appliance and describes how to connect those NICs to your network. The following NICs are
covered:
„
Four-Port 10/100 Mbps Ethernet Network Interface Card
„
Two-Port Copper Gigabit Ethernet Network Interface Card
„
Two-Port Fiber-Optic Gigabit Ethernet Network Interface Card
„
Four-Port T1 Network Interface Card
For instructions on adding or replacing NICs, see Chapter 5, “Installing and Replacing Network
Interface Cards.”
Caution
Protect your IP390 appliance and other electronic equipment from electrostatic
discharge (ESD) damage by making sure you are properly grounded before you touch
any electronic component.
Four-Port 10/100 Mbps Ethernet Network Interface Card
The IP390 appliance supports Nokia-approved, four-port UTP5 dual-mode 10-Mbps and 100-
Mbps Ethernet NICs.
When you purchase an Ethernet NIC with your IP390 appliance, the NIC is installed before the
appliance is delivered to you. For information on how to add or replace a NIC later, see
Chapter
5, “Installing and Replacing Network Interface Cards.”
Ethernet NIC Features
The Ethernet PMC NIC supports the following features:
„
Supports traffic at 10 and 100 Mbps
„
Packet tracing for analysis through tcpdump