Nokia IP390 - Security Appliance, Installation Manual

Page: 50 / 97

5
Installing and Replacing Network Interface Cards
50 IP390 Security Platform Installation Guide
If you do not deactivate the interfaces before removing the NIC, you may have to reinstall the
NIC to deactivate its logical and physical interfaces in Network Voyager.
For information about how to access Network Voyager, see
“Using Nokia Network Voyager” on
page 33.
Removing, Installing, and Replacing NICs
Note
Before removing a configured NIC with these instructions, you must deactivate the NIC in
Network Voyager. For additional information, see
“Deactivating Configured Interfaces” on
page 49.
Use these instructions to remove, install, or replace a NIC in the IP390 appliance. Some steps are
not applicable to all procedures. The instructions point out steps appropriate to each procedure.
Before You Start
To remove, install, or replace a Nokia NIC, you need the following:
„
A Phillips-head screwdriver
„
Physical access to the appliance
„
Access to the appliance by using Nokia Network Voyager or the CLI
„
Suitable, grounded work surface
„
Network interface card kit
To remove, install, or replace a NIC
Note
Because power to the IP390 appliance is automatically disconnected when the chassis
tray assembly is opened, you do not need to manually disconnect the power for this
procedure. Any servicing of the unit, however, should be completed with the chassis tray
assembly fully removed from the appliance. Power is still active in the chassis body and
care should be taken when working on the power supply or power supply wiring without
disconnecting the power cord.
1.
Use Network Voyager or the CLI to halt the appliance.
To use Network Voyager to shut the appliance down, select
System > Configuration > Reboot or Shutdown > Halt.
To use the CLI to shut the appliance down, enter halt at the prompt.