Nokia IP290 - Security Appliance, Installation Manual

Page: 51 / 81

Configuring and Activating Interfaces
Nokia IP290 Security Platform Installation Guide 51
The Nokia IPSO operating system automatically recognizes the NIC and applies the original
configuration to the new NIC.
12. Resecure the two chassis tray assembly retaining screws.
13. Replace the power cord.
14. Turn on the power.
Configuring and Activating Interfaces
The IP290 appliance automatically detects any new NIC when the appliance is restarted. Use
Nokia Network Voyager to configure and activate the logical and physical interfaces on the NIC.
For information about how to access Network Voyager and the related reference materials, see
“Using Nokia Network Voyager” on page 36.
Monitoring Network Interface Cards
You can assess the general operating condition of the NICs in your appliance by looking at the
LED status indicators on the NICs.
For the status indicator information for the built-in Ethernet ports, see
Figure 4 on page 18.
For the status indicator information for the Gigabit Ethernet NICs, see Chapter 4, “About IP290
Appliance Network Interface Cards.” .
Use Network Voyager to access detailed port information. For information about accessing
Network Voyager, see
“Using Nokia Network Voyager” on page 36. You can also use the IPSO
tcpdump command to examine the track on a specific port.
00563
IP290
STATUS
AUX RESET
1
3
5
2
4
6
CONSOLE
POWER
FAULT
SLOT 1
1000BaseT LINK
ACT
LINK
ACT