Nokia IP2255 - Security Appliance, Installation Manual

Page: 53 / 124

Using Nokia Network Voyager
Nokia IP2255 Security Platform Installation Guide 53
„
To connect 10 Gigabit Ethernet devices to the fiber-optic 10 Gigabit
Ethernet NIC, use a multi-mode fiber-optic cable with an LC connector
for each NIC interface.
The destination end of the cable can be either LC or SC, depending on the
type of connector required for the destination Gigabit Ethernet device.
You can also use a half-duplex LC-to-LC cable to loopback the transmit
port of an interface to the receive port.
For details, see “Fiber-Optic Gigabit Ethernet NIC Connectors and
Cables” on page 68
„ To connect 10/100 Ethernet devices to the 8-port Ethernet NIC or 10/100/
1000 Ethernet devices to the management ports, use a straight-through
cable with an RJ-45 connector.
For details, see “10/100 Ethernet NIC Connectors and Cables” on
page 61.
Using Nokia Network Voyager
Use Nokia Network Voyager to configure and monitor your appliance. For
additional information about how to use Network Voyager, see
“Viewing
Nokia IPSO Documentation by Using Nokia Network Voyager” later in this
section.
To open Nokia Network Voyager
1. Open a Web browser on the host you plan to use to configure or monitor
your appliance.
2. In the Location or Address field, enter the IP address of the initial
interface you configured for the appliance.
You are prompted to enter the admin username and the password you
entered when you performed the initial configuration.