Nokia IP2255 - Security Appliance, Installation Manual

Page: 103 / 124

Replacing the Management NIC
Nokia IP2255 Security Platform Installation Guide 103
One screw is located behind the ejector and locking lever and the other
screw is on the opposite side of the NIC.
Note
If you cannot tighten the retaining screws, the NIC is not installed
properly. Remove the NIC and reinstall it. The front plate of the NIC
must be flush with the chassis.
6. Press the power switch on both power supplies, located at the back of the
appliance, to turn on the appliance.
The security platform automatically recognizes the new four-port 10/100/
1000 Ethernet management NIC.
7. Reconnect the cables to the ports on the management NIC and access
Network Voyager by using the same connection you used before you
replaced the NIC.
If you cannot access Network Voyager, verify that the NIC is installed
properly. Verify that the status LEDs indicate a connection to the NIC and that
the NIC is sending and receiving data traffic.
If you still cannot access Network Voyager, or if the status LEDs do not
indicate a connection, see the
“Nokia Contact Information” on page 3 for
information about how to contact your Nokia service provider.