Nokia 10i, Installation Manual

Page: 33 / 48

Connecting Network Interfaces
Nokia 5i and 10i Installation Guide 33
Ethernet Cables
The Nokia 5i and Nokia 10i use IEEE 802.3 10 BASE-T, 100 Base-TX
shielded twisted-pair, CAT-5 ethernet cables.
To connect Ethernet devices:
„
Use a straight-through RJ-45 cable to connect to a 10-Mbps or 100-Mbps
hub or switch.
„
Use a crossover RJ-45 cable to connect directly to a host.
After you connect the network interfaces, you can perform the initial gateway
configuration. For information about how to configure the gateway, see
Performing the Initial Gateway Configuration in the Nokia IP VPN
Installation Guide .
Ethernet Cable Pin Assignments
Figure 5 shows the pin assignments for an RJ-45 cable. The RJ-45 cable
output connector is numbered from left to right, with the copper tabs facing
down and toward you.