Performing the Initial Hardware Configuration
Nokia 5i and 10i Installation Guide
29
Connecting Power and Turning the Power On
The power switch and receptacle for the power cord are located on the back of
the gateway, as shown in
Figure 3
.
The gateway power supplies automatically detects the input voltage (120
VAC [100 to 130] or 240 VAC [200 to 264]) and configures itself
appropriately.
Note
The Nokia 5i and Nokia 10i automatically powers on when the power
cable is connected.
Table 4 Pin Assignments for DB9 and DB25 Interface Cables
Console or serial
pin and assignment
DB9 cable-output pin and
assignment
DB25 cable-output pin and
assignment
Shield (FG)
Shield (FG)
1 (FG)
2 (RXD)
3 (TXD)
2 (TXD)
3 (TXD)
2 (RXD)
3 (RXD)
4 (DTR)
6 (DSR)
6 (DSR)
5 (SG)
5 (SG)
7 (SG)
6 (DSR)
4 (DTR)
20 (DTR)
7 (RTS)
8 (CTS)
5 (CTS)
8 (CTS)
7 (RTS)
4 (RTS)
Summary of Contents for 10i
