Nokia 10i, Installation Manual

Page: 25 / 48

Performing the Initial Hardware Configuration
Nokia 5i and 10i Installation Guide 25
To reset the Nokia 5i and Nokia 10i to factory defaults
1.
Remove power.
2.
Press the Reset switch.
Use a large flat-tipped object, such as a thick paper clip, to press the reset
switch.
Do not use a sharp pin or thin piece of metal to press the reset
button.
3.
Apply power and keep the switch pressed until the “wait after 0” message
appears on the console port.
The kernel boots and starts the configuration wizard.
For the front panel descriptions, see “System Status LEDs” on page 31.
Performing the Initial Hardware Configuration
The first time you turn on power to a Nokia 5i or Nokia 10i gateway, the
initial hardware configuration process begins.
This section describes how to perform the initial configuration manually by
using a console connection. It includes the following sections:
„ Connecting the Console Port
„
Connecting Power and Turning the Power On
Note
Nokia recommends that you install all hardware components before you
perform the initial hardware configuration.