27
c) Remove the cotter pin (3), the nut (4) and the washer
(5).
a) Lift the Tanden wheel with a jack and support the
wagon structure on stands, on safe points.
b) Remove the cover (2) using a screw-driver.
Disassembling the wheels hubs (1) for lubrication
d) Remove the wheel along with the hub (1) and the
other components.
e) Wash the ball bearings (6) with a brush and kerosene. If they are damaged, replace them.
f)
5
Lubricate the ball bearings (6) with the grease specified in page 2 .
g) Assemble the wheel hub (1) following the disassembling reverse order.
h) Adjust the ball bearings pre-load tightening the nut (4) until the wheel (or the hub) presents
a little resistance to turning.
I) Install a new cotter pin (3) and put the cover back.
j) Use the same procedure for the other wheels hubs.
1
1
4
5
2
3
6
Summary of Contents for VFN-9000
