Nlynx ETU400, User Manual

Page: 249 / 314

ETU400 User Guide 011603
E-11
PROBLEM
“ USR8258 File &1 not found, RECL must be non-zero to create the file ”.
CAUSE:
The host file you specified could not be found.
SOLUTION:
Specify a new file name or specify a record length (RECL) greater than zero preferably = or greater
than the file on the PC.
PROBLEM
“ USR8261 When parameter FRMMBR is *ALL, parameter TRANSLATE cannot be *DIF ”.
CAUSE:
The values specified for the FILETYPE and RECL parameters are incompatible with each other.
*DIF translation is not supported when transferring *ALL members from a Host data file.
SOLUTION:
The value for the FRMMBR parameter was specified as *ALL and the value for the TRANSLATE
parameter was *DIF. If the TRANSLATE type is *DIF, change the FRMMBR value to either *FILE,
*FIRST, or *LAST.
PROBLEM
" USR9013 DOS error code 0C - General failure (Probable error : media error) ."
CAUSE:
The diskette/disk adapter detected an error while trying to work with the diskette/disk.
SOLUTION:
Make sure the diskette drive closing mechanism is fully latched. Replace the diskette if in question.
The diskette may have been damaged during storage or formatted incorrectly. If the error remains,
or happens on a hard disk, then run DOS diagnostic programs to determine if the diskette/disk unit
is having hardware problems.
(See Also MAC ERRORS at the end of this doc.)
PROBLEM
“ USR9970 Invalid DIF header statements in the PC formatted file ”.
CAUSE:
While reading the DIF header statements, the DATA header item was not encountered or was
incorrectly specified.
SOLUTION:
Check that the DATA record is followed by a record containing 0,0 and another record containing "".