Nivus NivuFlow 750, Instruction Manual

Page: 83 / 162

Parameter Setting
NFM 750 - rev. 03 / 27.05.2020 page 83
Fig. 36-14 Programming using height, distance and angle
For sensor installation flush with wall you can alternatively enter the angle of incidence on-
ly (1-parameter programming).
The parameter is used as soon as there are wedge sensors fastened directly on the wall of
the slanted/bevelled area.
The use of the 1-parameter programming by entering the angle only requires an angle of in-
cident directed to the centre of the circular profile or segment as well as the installation situa-
tions mentioned above. However this method significantly facilitates correct programming.

Procedure:
1. Tick the >Flush with wall< checkbox.
This reduces the number of input boxes. Only the >Mounting angle< box re-
mains to be enabled.
2. Enter the sensor mounting angle.
3. Verify your input.
The graph now indicates the sensor showing the angle of incident entered.
Fig. 36-15 Parameter setting only by entering the angle