Nivus NivuFlow 750, Instruction Manual

Page: 127 / 162

Diagnostics
NFM 750 - rev. 03 / 27.05.2020 page 127
45 Diagnostics Menu h-Sensors
Fig. 45-1 Menu Diagnostics h-Sensors
This menu has a relation to the menu >Applications</>h-Sensors<. Depending on the type
and number of sensors defined here the sections are indicated in the corresponding colours.

See chapter “36.2 Setting Parameters in Menu h-Sensors”.
The Diagnostics screen shows the current level and the shaft level. The adjustment height
can be set and must be confirmed with OK. The adjustment height is equal to the offset and
is normally specified when the h-sensor parameters are set.
Depending on which sensors are selected the value, the calibrated value or the raw value are
indicated.
•
Value: issued value
•
Calibrated value: corrected used value
•
Raw value: real measured value
Moreover, it is possible to indicate information on “Signal scan env.”, “Signal scan”, “Tx sig-
nal”, “Noise” and “Sensor test” (depending on the connected/selected sensor type) if re-
quired.
Various commands such as “Near blanking”, “Window width”, “Set blanking”, “Reset blank-
ing”, “Update blanking” and “Reset sensor” can be selected and executed in this menu as
well.