Diagnostics
page 141
NF 650 - rev. 01 / 29.06.2020
40 Diagnostics h-Sensors
Fig. 40-1
Menu Diagnostics h-Sensors
This menu has a relation to the menu >Applications< / >h-Sensors<. Depending on the type
and number of sensors defined here the sections are indicated in the corresponding colours.
F
c
See Sect. “32.3 Setting parameters in h-Sensors Menu”.
The Diagnostics screen shows the current level. The adjustment height can be set and must
be confirmed with OK. The adjustment height is equal to the offset and is normally specified
when the h-sensor parameters are set.
Depending on which sensors are selected the value, the calibrated value or the raw value are
indicated.
• Value: issued value
• Calibrated value: corrected used value
• Raw value: real measured value
With the >Diagnostics< button it is possible to indicate information on “Signal scan env.”, “Sig-
nal scan”, “Tx signal”, “Noise” and “Sensor test” (depending on the connected/selected sensor
type) if required.
Various commands such as “Near blanking”, “Window width”, “Set blanking”, “Reset blanking”,
“Update blanking” and “Reset sensor” can be selected and executed in this menu as well.
