Setting Parameters
page 131
NF 650 - rev. 01 / 29.06.2020
The same procedure can be used to specify the desired number of
decimal digits
. Here a
maximum of five decimal digits is possible.
Note
During setting the decimal digits observe the measurement accuracies of the sensors and
the measurement units set.
The temperature sensor e.g. has a maximum resolution of 0.1 K.
The display fields 2, 4 and 5 offer setting options for two values each. The following applies
>Value Tab 1< for measurement place 1 and >Value Tab 2< for measurement place 2.
The selection options are:
• Output field 2: >Level<, >Analog input 1<, >Analog input 2< and >Not active<
• Output field 4: >Water temperature<, >Air temperature<, >Analog input 1<, >Analog
input 2< and >Not active<
• Output field 5: >Total<, >Analog input 1<, >Analog input 2< and >Not active<
37 Connections Parameter Menu
This submenu exists for multiple measurement place transmitter types (T4 and TM) only or
for transmitter types which can be connected to extension modules (even if used only for one
measurement place, types TM and TZ).
The extension modules are defined here: Arrangement/Setup and Baudrate.
The assignment of the terminal strips for the analog inputs/outputs and the digital inputs/out-
puts to the measurement points is defined in this menu. This assignment is used to display the
calculated values (e.g. in the main display and in the parameter menus of the measurement
points) and, if necessary, for the subsequent calculation with the values. The inputs/outputs
first need to be assigned in the Connections menu so that they can be displayed and parame-
terized in the measurement place menu.
Fig. 37-1
Connections menu
