Attention: Please remove any descaler residues on the casing immediately with a damp cloth.
5.6. Regular manual cleaning
Note: Please follow these cleaning instructions. Working with foodstuffs demands the highest degree of
cleanliness.
Attention: Never immerse the appliance in water! Do not use abrasive cleaning agents.
➔
Use a soft, damp cloth for cleaning the casing inside and out.
➔
Empty drip tray (fig. 1/N) and used coffee container (fig. 1/O) at the latest when this is indicated
on the display (only when the appliance is switched on!).
Note: Make sure when cleaning the drip tray (fig. 1/N) that both metal contacts at the back are clean
and dry! Use a little detergent every now and again.
➔
The water tank should be rinsed daily with clear water and then be re-filled daily with fresh cool
water.
Note: Dried milk residue is difficult to remove.
➔
Therefore clean frother, hose and spout regularly.
Tip: From time to time (ideally each time the appliance will not be used for a while, at any rate in
regular intervals!) the frother needs to be completely dismantled and thoroughly cleaned under running
water.
➔
Remove the panel from the spout (fig. 1/P).
➔
Pull the frother down and out (fig. 11) and dismantle it completely (fig. 1/R).
➔
Reinsert the assembled frother into the spout (fig. 11).
➔
Replace the cover (fig. 1/P).
Tip: Your appliance is equipped with back rollers (fig. 1/Q), which allows you to move the appliance on a
flat working top. This way, you can also clean the space underneath the appliance.
5.7. Cleaning the brew unit
Attention: Remove the brew unit only when the appliance is switched off.
Attention: Please clean the brew unit regularly, for instance after each cleaning programme, but at least
once a month. Otherwise your warranty could be compromised.
When necessary the brew unit can be removed and cleaned under cold, running water. Never use any
cleaning agent, but clear, cold water only! For hygienic reasons we recommend the removal and clean-
ing of the unit thoroughly after each run of the cleaning program (see 5.4.).
➔
Open the service door on the right of the casing (fig. 1/L) towards you.
➔
Remove the brew unit by pressing the red switch and turning the handle all the way to the left
until it snaps into place (fig. 12).
➔
Carefully remove the brew unit using the handle.
➔
Clean the brew unit under running cold water and let it dry.
➔
Reinsert the brew unit carefully and lock by pressing down the red switch and turning the handle
all the way to the right until it snaps into place.
➔
Close the service door and in doing so carefully place the pivots at the back of the door into the
notches. Make sure that the door (fig. 1/L) completely snaps back into place.
5.8. Changing the filter
The filter will be flat after about 50 l of water have been drawn. The display shows
“CHANGE FILTER”.
You can still make coffee, but we recommend changing the filter immediately.
➔
Turn the rotary control to “SETTINGS” and press it.
86
GB
5. Cleaning and maintenance
04_Niv_859_BDA_sw_GB_03.indd 86
13.04.17 15:42
