Nitto Flowtech MF710, Operation Instruments

Page: 20 / 41

TM
Ⅲ
. Instrument started
1 .Working instrument showing
2 . Interface show
Before connect power, follow the manual of the first part of the note 1,2 and sensor part of the installation
manual to verify whether the system is properly installed and connections. End customer can directly run
instrument, the reason is including sensors and signal transmitter of two parts, all of the data have been based
on user requirements and technical specifications of the company's manufacturing process in the factory setting.
After complete correct electric connection, run power on instrument. Instrument transmitter first
implementation of the initialization; display the company logo (see below). Wait 3 seconds after the
instrument into the own measurement mode, immediately began to flow measurement and displays the
current flow measurement value or other self-assemblies off information. If there is no meter to power
after the show (display without backlight), then the power supply and connectivity in identifying ways to
meet the requirements, may view the instrument power supply fuse is intact (you can see the 8 common
faults and processing).
If there is no meter to power after the show (display without backlight), then the power supply and
connectivity in identifying ways to meet the requirements, may view the instrument power supply fuse is
intact (you can see the 8 common faults and processing).
TRANSIMITTER
17
CONVERT PARTS
TM
Http: // www.flowmeter.cc
CONVERT
Flow direction
Instantaneous delivery
Unit of instantaneous delivery
Total accumulated
Unit of total accumulated
Warn of instrument
Percentage of flow
8
L
ｓ
m
3
.
8888888.8
888 8
１００％
＋
Alarm Condition
Keyboard Lock-up Condition
Flow Calibration
Edition number of program
m
3
8888888.8
m
3
8888888.8
m 10.008
ＣＢＭ＿Ｅ８３０８Ｓ．Ｃ５
ｓ
Ｆｏｒｗａｒｄ ｔｏｔａｌｉｚｅｒ
Ｂａｃｋｗａｒｄ ｔｏｔａｌｉｚｅｒ
ｆｌｏｗ ｒａｔｅ
Alarm
----
Excitation Over range
zero blank pipe
upper limit Lower limit
Alarm Interface
Flow Auxiliary Interface
----