NITEO TOOLS
EN
44
NITEO TOOLS
First fill the water supply hose with water. After shutting off the tap water supply
connect the hose using the garden quick-connector to water inlet connector and make
sure that the fitting is leaktight and solid. Supply the tap water to the unit.
Release the security button in the spray gun and press the trigger. Wait for about
2 minutes. Release the trigger of the spray gun. Press the power switch on the device
and push the trigger of the spray gun.
Water should gush from the gun after one minute at most.
If water does not flow from the gun after 2 minutes, turn off the power immediately,
as the pump in the device may get damaged. Disconnect the unit from the mains and turn
off the water supply to the unit. Press the trigger on the spray gun and wait two minutes
until the water pressure drops. Check all connections and that any hoses (garden and/or
pressure) are not broken or otherwise damaged.
USE OF DEVICE
After correct installation and commissioning you can start using the device.
Pressing the trigger (with the safety disabled) will switch on the pump and spray the
water under pressure from the nozzle. Releasing the trigger in the spray gun will stop
the water supply. The pump should stop after a short while. It resumes its operation
when the trigger of the spray gun is pressed and the pressure in the device drops below
the value set by the manufacturer.
You can start washing. The water jet can be controlled by rotating the spray nozzle
element.
