NITEO TOOLS
EN
NITEO TOOLS
43
only used for covering washed surfaces with foam. In other cases, the container should
be removed from the nozzle.
NETWORK CONNECTION
The appliance can be powered by single-phase 220-240V ~ 50-60Hz. It's Class II
electrical appliance, which means that it can be operated without a protective
conductor when plugged into sockets.
Before connecting the unit to the mains, check that the mains voltage corresponds
to the operating voltage on the unit's nameplate.
COMMISSIONING
Connect only sources of clean, preferably filtered, water to the unit, so that no dirt
that could damage pump components can get inside the unit.
The temperature of water supplied to the device should be between 5-
40°C. Using
colder or warmer water can damage the components.
The pressure of water supplied to the device should be between 0.1-1 MPa. Higher
or lower water pressure can damage the unit.
The temperature of the environment during operation and storage should be higher
than 0°C. Freezing water can damage the unit.
When operating the device, the user should wear a waterproof protective suit,
suitable protective goggles and gloves. Protective clothing not included.
Inspect technical condition of the appliance and its accessories before starting work,
also check its safety of use. If the technical condition of the appliance is
n’t flawless then it
can't be approved for operation. If the unit is damaged, it must be repaired before it can be
used again.
Place the unit on a firm surface where it will not be exposed to flooding or spraying
from the water source as well as when using the unit. Expand the power cord
completely and plug it into the power outlet. Expand the pressure hose completely and
connect it to the nozzle on the back of the unit and to the spray gun as shown in the
section on installation. Connect the spray gun extension to the spray gun and the
adjustable nozzle tip to the spray gun extension.
