14
5. Once the cards are loaded, place the card weight on the top card with the raised bevel
handle facing away from the printer. This card weight increases feeding reliability
primarily when only a few cards are in the card feeder.
6. Close the card feeder door. The cards will automatically feed off the bottom first.
Note
Stack the cards evenly to prevent the printer from reporting a “pick up error”.
Card Size Adjustments
When loading cards that vary from the standard size, it is necessary to make a simple adjustment
to the printer. To adjust the card size, follow these steps:
1. Open the card feeder door and remove cards.
2. Loosen the two phillips head screws on the adjustable gate.
3. Insert a card into the card feeder just under the gate.
4. Lower the gate until it slightly touches the card.
5. Raise the gate one half the thickness of the card and tighten the screws.
6. Test the new adjustment by attempting to slide two cards under the gate. If two cards
slide under the gate, the gap width is incorrect and return to step 3. You should not be
able to slide two cards into the gap.
Summary of Contents for PR5300
Page 2: ......
Page 45: ...41 PR5300 Block Diagram Flip Turn Feeder Print Unit Encoder...
