D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
10
3) How to Change the paper width
[How to change the paper width of NP-2651 58mm
→60mm]
Before Change:
Paper Width 58mm(Default)
Move Guide, Bracket, and Shaft.
*Keep power turn OFF.
(1)Move Guide
*Please beware of floating or bending of guide and loosening
Screw.
(2)Move Bracket
(3) Move Shaft
*Please wear groves and beware not get injured with your fingers.
After change Paper width 60mm
[Note]
・
Arm attaching side is changeable when paper width 58mm and 60mm.
Please refer to (2) on the next page.
Bracket
Remove screws
(4 place) roundhead
screws M3x5
Screw hole is
visible
Move bracket to the position
Of picture, hold firmly, and fix it (4 places)
+Roundhead screws M3x5
Screw hole is
visible at the
opposite side
before moving.
Guide
Bracket
Shaft
Unscrew (1 place)
+RoundheadscrewM2x4,0#
)
Guide
No
interspace
Please move guide at the
position of picture, hold it,
and fix it(1 place)
+roundheadscrewM2x4,0#
Paper table
Interspace
Set boss.
(No Float)
Open Thermal head cover.
Shaft
Loosen screw
(Until screw head floats like
1mm height)
+roundhead screws
(B tight)M2.6
Move shaft to the lever side
for one chase with holding
up the spring.
Fix it (1 place)
Move shaft for one chase
Lever
Before
moving
After moving
