D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
39
4.8 How to set Roll Paper
*Please refer to this section when removing roll paper.
1) Set roll paper to the paper holder[UPH-Arm_W_Unit].
(For both NP-3611/2611)
(1)Open the roll paper support shaft stopper as shown in the following figure and put the paper
support shaft through the roll paper.
(Please do not apply excessive force when opening the roll paper support shaft stopper.)
(Please pay attention to the direction of roll paper.)
(2) Please put the roll paper support shaft stopper back to the initial position.
[Note]
・
Please do not deliver while paper roll is set.
・
Please do not apply excessive force to UPH-Arm_W_Unit when setting and unsetting paper
Roll. It may cause any failure.
(B) Available to set and unset
ll
(A) Prevention for falling roll
Stopper of roll paper
UPH-Arm_W_Unit
Print side
Paper roll
Winding
di
ti
Stopper of paper support core
