D-F10137 NP-2651/3651 Product Spec. Rev.0.01(Provisional)
16
3) Consumption Current
[Condition] Partition Drive: Optimization, Power Supply Voltage:DC24V, Temerature:25
℃
,
Print Density:100%
NP-2651
NP-3651
Print ratio
Approx.18%
(Refer to print example)
ANKRolling 50lines
(Repeat "A~Z", "0~9")
+Paper feed 5lines
+Auto cut
100%
(Refer to print
example)
Print length 20mm
Approx.18%
(Refer to print example)
ANKRolling 50lines
(Repeat "A~Z", "0~9")
+Paper feed 5lines
+Auto cut
100%(Refer to print
example)
Print length 20mm
Print contents
Font A 34 digits
Print width 52mm
(416dot)
Font A 48 digits
Print width 72mm
(576dots)
Print example
34 digits
ABCD
～
UVWXYZ01234567
89ABCD
～
UVWXYZ012345
6789ABCD
～
UVWXYZ0123
・
・
・
OPQR
～
89ABCDEFGHIJKL
MNOPQR
～
89ABCDEFGHIJ
KLMNOPQR
～
89ABCDEFGH
52mm
48 digits
ABCD
～
98ABCDEFGHIJKL
MNOPQR
～
MNOPQRSTUVWX
YZ012345
～
0123456789
・
・
・
YZ01
～
WXYZ0123456789
ABCDEF
～
ABCDEFGHIJKL
MNOPQRST
～
OPQRSTUVWX
72mm
Indication of
consumption
current
Average: Approx. 1.5A
Peak: Approx. 8.0A
Average:Approx. 5.1A
Peak: Approx.8.2A
Average: Approx.1.9A
Peak: Approx. 10.3A
Average:
Approx.6.8A
Peak:
Approx.11.6A
[Note]
・
Print width and Partition drive are set with default value of this product.
・
Print ratio
*1
=
Print current dot number
÷
Total dot number of head.
*1
：
When operating to print exceeding print ratio 60% with NP-3651, please select partition drive for
optimization or dual partition print.
・
Please keep power supply voltage not to exceed its range under any condition since deterioration or
breakage immediately occurs once it exceeds the range.
・
Please use the power supply with sufficient capacity and connect every lines for ensuring print quality
since large amount peak current flow depending on power supply voltage and print contents. Also,
please use wiring materials such as AWG#16 or equivalent.
・
If power supply cable is excessively long, the operation may become unstable. Cable should be
made as short as possible. If not available, connect cables near the printer and place an
electrolysis condenser of 2200μ between power supply and ground. Please wire not to
electromagnetic effect to power supply line and signal line of printer due to other power supply line,
etc. Also, please use withstand voltage: 35V or more.
・
Please use LPS power supply as recommended.
