30
■ Operating Method
● When starting the operation or during the operation, check periodically if the chain oil is discharged.
* Follow "5.1.4 Discharging Condition Check and
Adjustment of Chain Oil".
● Adjust the discharge amount of the chain oil.
* Follow "5.1.4 Discharging Condition Check and
Adjustment of Chain Oil”.
● Put the pole pruner at right angle to the branch
when cutting.
● Predict the drop position of branches to be cut,
and operate where you are not hit by the falling
branches.
● Hold the pole pruner so that the shaft tube is at 60°
or less to the horizontal line.
● Cut the branch into an appropriate size from the tip
towards the root of the branch.
● Pay attention to the branches which are fallen and
bounced back from the ground.
● Put the pole pruner at right angle to the branch
when cutting.
● Do not use the tip of the guide bar for cutting.
4.6 Actions after Operation
After using the pole pruner, take the following actions.
Turn the start/stop switch of the engine to OFF (○) to stop the engine.
Tighten all the screws except for nuts, bolts and screws for adjusting the
Carburetor.
Store the pole pruner according to “6 Storing.”
max.60
°
1
2
3