20
Remove the guide bar [7] and saw
chain [6] from the transmission case.
3.1.2 Installation
Install the saw chain [6] to the guide
bar [7].
Set the saw chain in the appropriate
position, and install it with the
tensioning hole and tensioning pin
aligned, and then set the saw chain
into the drive sprocket.
Turn the tensioning bolt [3] clockwise
until the slack amount of the saw chain
becomes a little.
Note
● Check the saw chain is set in the gauge
(groove) of the guide bar, when apply tension
to the saw chain.
Install the chain cover [2], and lightly
tighten the guide bar nut [1].
[6]
[7]
5
[6]
[7]
1
2
[3]
3
[1]
[2]
4