5. Operation
5. Operation
.22.
.23.
5.3.2 Set Address
This function is used for set the address when mutiple inverters are connected to single
monitor.
The address number can be assigned from “01”to “99”. The default address number is “01”.
5.4.2 Warning Message
The display shows the 100 latest warning messages.
5.4 Advanced Info
5.4.3 Running Status
This function is for maintenance person to get running message.
General status includes: DC bus voltage, power factor, power l imit, inverter temperature, grid
standard
Advanced status includes: Control word status, Grid filter No.,Ground voltage, etc.
Select “Advanced Info.” from the Main Menu. The
screen will require the password as below:
5.4.4 Communication Data
The screen shows the internal data of the Inverter, which is for service technicians only.
The default password is “0010". Please press “down” to move the cursor, press “up” to
select the number.
After entering the correct password the Main Menu will display a screen and be able to
access to the following information.
1.Alarm Message 2
.
Warning Message 3. Running Status
4.Communication Data 5
.
Yield Profile
5.4.1 Alarm Message
The display shows the 100 latest alarm messages.
5.4.5 Yield Profile
The section shows the energy records of the battery, grid, load and backup port.
→
Energy Battery
Energy Grid
Figure 5.14 Yield profile
Figure 5.8 Set address
YES=<ENT> NO=<ESC>
Set Address: 01
NOTE:
To access to this area is for fully qualified and accredited technicians only.
Enter menu “Advanced Info.” and “Advanced settings”
（
need password
）
.
Figure 5.9 Enter password
YES=<ENT> NO=<ESC>
Password:0000
Figure 5.10 Alarm message
Alarm000: ACOvercurrent
T: 02-21 22:15 D: 0000
Figure 5.11 Warning message
Msg000:
T: 00
-
00 00
:
00 D
:
0000
Figure 5.13 Communication data
01-05: 00 00 00 00 00
06-10: 00 00 00 00 00
→
General Status
Advanced Status
Figure 5.12 Running status
