Nilfisk-Advance Hybrid Typhoon, Directions For Use Manual

Page: 17 / 112

17
Eng
lis
h (
EN
)
8. Operation
8.1. Before Operation
The pipeline must be rinsed through
before the system is connected.
8.2. Start/Stop (change, rinse, foam, des)
Start the unit
1. Check that the power supply is conneted and the
water supply for the system is open.
2. Select requested function. Use the unit according
to the ”User Guide”.
Stop the unit
3. Disconnect the power supply
4. Close the water supply
It is important to close the water when
the unit is left after use .
• If the water supply is left open when the unit is not
in use, water might seep into the product pick up
line if the non-return valve on the injector block is
leaking.
Water seeping back in to the product pick up line will
dilute the product in the can and this will effect the
foam quality when foaming with the unit.
CAUTION
The chemical supply must always be
rinsed thoroughly after use
5. The following procedure will clean the chemical
supply for detergents and/or remains of disinfect-
ants:
• Remove User Pack or the cans.
• Hold the rinsing bottle with clean water tightly
against the suction opening (with User Pack). Al-
ternatively, you can place a User Pack with clean
water in the holder or – without User Pack – place
the hose in a bucket of clean water.
• Activate the hose handle until clean water comes
out of the nozzle (approx. 30 seconds).
Display functions
1 Start (The unit is turned on)
2 Stop (The unit is turned off)
3 Error (See display)
4 Compressor on
5 Compressor off
6 Pressure 25 bar (only on Hybrid Typhoon 40)
7 Pressure 40 bar (only on Hybrid Typhoon 40)
4 6
7
2
3
1
5
110004582