FORM NO. 56043089 / AquaRide
™
/ BRX 700 - 37
37
37
37
37
SOLUTION SYSTEM
SOLUTION SYSTEM
SOLUTION SYSTEM
SOLUTION SYSTEM
SOLUTION SYSTEM
MAJOR COMPONENTS SPECIFICA
MAJOR COMPONENTS SPECIFICA
MAJOR COMPONENTS SPECIFICA
MAJOR COMPONENTS SPECIFICA
MAJOR COMPONENTS SPECIFICATIONS
TIONS
TIONS
TIONS
TIONS
Nozzle and Pump Data
Nozzle and Pump Data
Nozzle and Pump Data
Nozzle and Pump Data
Nozzle and Pump Data
Flow Rate
Flow Rate
Flow Rate
Flow Rate
Flow Rate
Components
Components
Components
Components
Components
GPM / Working Pressure
GPM / Working Pressure
GPM / Working Pressure
GPM / Working Pressure
GPM / Working Pressure
Nozzle (A)
(A)
(A)
(A)
(A) “Maintenance”
.55 GPM
Spec. .057” orifice diameter
Hardened Stainless Steel
Nozzle tip I.D. QSTK-SS-3.0
Nozzle (B)
(B)
(B)
(B)
(B) “Restoration”
.98 GPM
Spec. .091”orifice diameter
Brass
Nozzle tip I.D. QTKA-BR7.5
Pump Specifications
Pressure relief switch opens at 100 PSI
Max. flow rate 1.6 GPM
Max. current 3A (average current 2.7A)
NOZZLE MAINTENANCE
NOZZLE MAINTENANCE
NOZZLE MAINTENANCE
NOZZLE MAINTENANCE
NOZZLE MAINTENANCE
See Figure 4. To inspect and clean both nozzles no tools are needed. First remove the Wing Nut (G)
(G)
(G)
(G)
(G) that secures the nozzle bracket
(tree) and pull it from the brush housing slots with the hoses still connected.
To remove a nozzle to clean or replace just grip the nozzle tip and at the same time press in and twist it a 1/4 turn to separate it from
the nozzle body. Note: Suggested once a week to inspect and clean nozzles.
Clean by soaking nozzles overnight in a full strength vinegar solution or properly diluted and handled meratic acid solution to remove
build up of chemical deposits. Note: Do not ream out (increase) the orifice by cleaning with a drill bit. As this will affect the nozzle
working pressure and spray pattern.
NOZZLE FIXTURE INST
NOZZLE FIXTURE INST
NOZZLE FIXTURE INST
NOZZLE FIXTURE INST
NOZZLE FIXTURE INSTALLA
ALLA
ALLA
ALLA
ALLATION
TION
TION
TION
TION
1
11
11
Apply small amount of thread sealant (Loctite #242-blue) to the fixture threads.
2
22
22
See Figure 3. Thread the Nozzle Fixtures (H)
(H)
(H)
(H)
(H) into each brass barb.
3
33
33
Position nozzle fixture as shown (nozzle fixture flat must be 90º to bracket arm).
FIGURE 3
FIGURE 3
FIGURE 3
FIGURE 3
FIGURE 3
B
A
H
Bracket
Flats
Flats