FORM NO. 56043089 / AquaRide
™
/ BRX 700 - 33
33
33
33
33
SCRUB BRUSH SYSTEM
SCRUB BRUSH SYSTEM
SCRUB BRUSH SYSTEM
SCRUB BRUSH SYSTEM
SCRUB BRUSH SYSTEM
FRONT
Belt
Brush
Right Motor
Left Motor
Belt
+
-
BLK
BLUE
CCW Rotation
from shaft end
CCW Rotation
from shaft end
3/4" to 7/8" (19-22mm)
SCRUB BRUSH SYSTEM MAINTENANCE
SCRUB BRUSH SYSTEM MAINTENANCE
SCRUB BRUSH SYSTEM MAINTENANCE
SCRUB BRUSH SYSTEM MAINTENANCE
SCRUB BRUSH SYSTEM MAINTENANCE
The scrubbing system must be serviced at regular intervals to
maintain good scrubbing performance. Follow the mainte-
nance steps listed below.
1
11
11
Rinse clean, built up debris from the debris hopper drain
holes (daily).
2
22
22
Remove any string wrapped around the scrub brush, drive
hub and idler hub (daily).
3
33
33
Clean spray nozzles attached to the front of the scrub deck
(weekly).
4
44
44
Clean built up dirt from the inside of the scrub brush
housing (weekly).
5
55
55
Remove both the scrub brushes and rotate, turn end for
end (weekly). See
Scrub Brush Removal and Installation
(Cyl) section.
6
66
66
Inspect the scrub brush bristles for wear, the brushes
should be replaced when the bristle length is 1 inch (26
mm) or less (monthly).
FIGURE 6
FIGURE 6
FIGURE 6
FIGURE 6
FIGURE 6
SCRUB BRUSH REMOV
SCRUB BRUSH REMOV
SCRUB BRUSH REMOV
SCRUB BRUSH REMOV
SCRUB BRUSH REMOVAL AND INST
AL AND INST
AL AND INST
AL AND INST
AL AND INSTALLA
ALLA
ALLA
ALLA
ALLATION
TION
TION
TION
TION
1
11
11
Make sure the key switch is off and disconnect the battery pack before servicing.
2
22
22
See Figure 4. Loosen the black knobs (one on each side) that secure the removable bearing idler support Plate (Z)
(Z)
(Z)
(Z)
(Z) to the brush
housing, then pull the plates down and out to remove. Grip the scrub brush and slide it out from the housing end.
3
33
33
To install the brush slide it into the housing, lift slightly, push and turn until it seats into the drive end assembly.
4
44
44
Re-install the idler end plate assemblies.
FIGURE 5
FIGURE 5
FIGURE 5
FIGURE 5
FIGURE 5