We
reserve the right to make changes
Page 25 of 49
Superuser/ Installer – Settings
General settings – Language file uploading
You can install new languages and update existing languages in the control panel.
Update via USB plug
General settings – Display
You can adjust display light intensity.
You can adjust interval before the display reverts to standby.
General settings – Buzzer mode
Switch key beeps on or off.
CP – Settings
You can set Compact P ventilation to produce domestic hot water.
Reheater type *
None
No heating coil
Water
Water heating coil
Analog
Electric heating coil
AllowHeat deadband ***
°C
Setting for regulation neutral zone
Lock signal type *
None
No blockage
Heat
Heating input blocked
Cool
Cooling input blocked
Fire alarm auto reset *
Off
Not activated
On
Allows external fire automation system access to week-
ly test
Deicing
Deicing pause
Minimum de-icing interval
Out-temp to deice (°C)
At which outdoor temperature must the frost protection
system begin to monitor the unit?
Deice max. time (min)
Maximum interval for de-icing the counterflow heat
exchanger
Evapo-
rat.deiceTime(min)
Maximum interval for de-icing the evaporator
Deice fan speed (%)
Extract air ventilator speed during de-icing
Deice fan mode
From: Fresh air ventilator OFF
T6 hold time (min)
Hold time at T6 defrost stop temperature
Released: Fresh air ventilator ON (normal setting)
Previous: Air intake fan runs at same setting as extract
air fan during de-icing
Compressor**
Comp. start-start(min)
States interval between compressor starts
Compr.min off
time(min)
States interval between compressor start and stop
VFD config *
Min
Steuerspannung
FU 1
Fresh air ventilator setting at 20% air
Max Steuerspannung
FU 1
Fresh air ventilator setting at 100 % air
Min
Steuerspannung
FU 2
Extract air ventilator setting at 20% air
Max Steuerspannung
FU 2
Extract air ventilator setting at 100% air
Used to regulate ventilators when duct sets are not the
same
Preheater settings
Polar functionality
Modulating pre-heating element pulses heat when ex-
