36
support.hysecurity.com
Note: The button on the OXI receiver is not needed for
programing fobs for the SmartCNX and should
not be pressed during the following installation
processes.
Install and enable the OXI receiver:
1. Remove the OXI port rubber plug.
2. Install the OXI receiver.
3. Install a whip or coaxial antenna into the OXI antenna
terminal for better range (Figure 49). Mount any
external antenna onto the top of a fixed fence post
near the operator.
4. Press MENU on the SmartCNX Controller.
5. Press the UP or DOWN arrow to navigate to
EXTERNAL COMMUNICATIONS and press SELECT.
6. Press the UP or DOWN arrow to navigate to OXI
RADIO MENU OPTIONS and press SELECT.
7. Press the UP or DOWN arrow to navigate to OXI
ENABLE and press SELECT.
8. Press the UP or DOWN arrow to select ON and press
SELECT.
Pair a fob:
1. Open OXI RADIO MENU OPTIONS (steps 4 - 6 to
install OXI).
2. Press the UP or DOWN arrow to navigate to KEY
FOB PAIRING and press SELECT.
3. Press the UP or DOWN arrow to select the function.
4. Press and hold the appropriate button on the fob.
5. Press SELECT. Display will beep and state PAIRED.
6. Repeat steps 2-5 to pair additional fob buttons or
fobs.
7. Press MENU until gate status displays.
8. Press the buttons on the fob to test operation.
Remove a single fob in hand:
1. Open OXI RADIO MENU OPTIONS (steps 4 - 6 to
install OXI).
2. Press the UP or DOWN arrow to navigate to KEY
FOB REMOVAL and press SELECT.
3. Press the UP or DOWN arrow to select 1 (ON).
4. Press and hold the button on the fob and press
SELECT to remove.
5. Repeat steps 3 and 4 for every fob button to be
removed.
Remove a single fob from a list:
Note: It is important to keep a log of fobs and who is
responsible for each for this method.
1. Open OXI RADIO MENU OPTIONS (steps 4 - 6 to
install OXI).
2. Press the UP or DOWN arrow to navigate to KEY
FOB LIST and press SELECT.
3. Press the UP or DOWN arrow to navigate to the fob
number in the list and press SELECT.
4. Press the UP or DOWN arrow to select Y and press
SELECT. This removes the fob.
Remove all fobs:
1. Open OXI RADIO MENU OPTIONS (steps 4 - 6 to
install OXI).
2. Press the UP or DOWN arrow to navigate to
REMOVE ALL KEYS and press SELECT
3. Change the setting to 1 (YES) and press SELECT.
OXI INSTALLATION AND PROGRAMMING
Figure 49. OXI Antenna Terminal
COM
SIG
Shield
Core
Figure 50. Remove OXI Port Rubber Plug
Figure 51. Install OXI Receiver
Note: For older OXI
receivers, use the
antenna terminal
on the SmartCNX
controller. For newer
OXI receivers use the
antenna terminal on
the OXI receiver.