Nice HySecurity SwingSmart CNX 20, Basic Installation And Programming Manual, Page: 32 / 56

32
support.hysecurity.com
LIST OF ENTRAPMENT SENSORS
Table 21. Sensors Tested for Use with HySecurity Operators
Mfg. Part # Mfg. Details
10k or 4-Wire
Pulsed
Hysecurity Part #
Photo Eyes
(Retrorefl ective)
E3K-R10K4-NR-1 Omron 40 ft max range limit 10k MX000999
NIR-50-325 EMX 45 ft max range limit 10k
IRB-RET EMX 53 ft max range limit Both
E-931-S50RRGQ Seco-Larm 46 ft max range limit 10k
Photo Eyes
(Through-Beam)
IRB-MON EMX 65 ft max range limit 10k MX3990
E-960-D90GQ Seco-Larm 90 ft max range limit 10k
BlueBUS Nice 65 ft max range limit
Edge Sensors
Sentir Series ASO Safety
Channel mount, high profi le
Channel mount, low profi le
Round, wraparound
Square, wraparound
10k
AS1502-0440-05
AS1502-0430-05
AS1501-0760
AS1501-0790
CPT210-2U-#-T2 Miller Edge
10k resistor termination
(replace # with length
requirement in feet)
10k
Edge, Wireless
Kits
iGAZE RE Kit
Transmitter
Solutions
50 ft line of sight max range
limit
10k
WEL-200 (kit
with receiver and
transmitter)
EMX
200 ft line of sight max
range limit
Both
COMPATIBLE EXTERNAL SENSORS
Note: Additional entrapment sensors can connect to Sensor 1 - 2 and Inputs 1 - 3
An example wiring diagram is shown below for a non-contact sensor (photo eye). Set any DIP-switches and jumpers according
to manufacturer instructions for 10k normally open.
Example wiring for the EMX IRB-MON transmitter and receiver.
NOTICE
The SmartCNX Controller inputs use 10k or 4-wire pulsed monitoring. Connect sensor using sensor instructions for the
compatible output connections. The SmartCNX Controller does not support normally closed inputs.
POWER POWER
POWER
INPUT
POWER INPUT
NO
NO NC
COM
COM